I just bought a used T190 with 1080 hours. Used it approximately 20 hours and it was working fine when shut down at the end of the day. The next evening when i cranked it up within 20 seconds a continuous alarm sounded and a light noted overheat coolant but no code. I came back the next morning cranked the engine, no coolant code, alarm or light but within 30 seconds the hydraulic alarm sounded with a light and three repeated beeps. Talked with the dealer and they seemed to think the computer needed re-programed. Any thoughts or ideas, i usually do my own maintenance but this is very unusual. I have in the past disconnected the battery on my car to reset the computer, do you think this would work on the Bobcat? Thanks Tnfarm