I have a small 530 machine that I wanted to pick up a small backhoe for. I believe there are a few flavors of the 905 available. Does anyone know which ones will fit my machine? Thank you
Thanks for the reply. Unfortunately I do not see the manual I need for the 530. I am looking for a wiring diagram for the machine if anyone has one they could send until I can order a manual.
Just picked up a 530 project that has the lift arm spool stuck in the lift position. I check the entire linkage and it is free. The problem seems to be the spool itself. The spool is different than my 742. Is there a detent that could be stuck?
I just finished digging a swimming pool with my 909. The stabilizer cylinder on the one side started leaking. I went to bobcats website but the 909 does not have a parts diagram for it. Does anyone have a part number for a seal kit? I want to order one. Thank you
I currently own one, i wanted a 743 but one came available so i picked it up. In some ways i wish i had the diesel, on the other hand the maintenance of the gas engine is a lot cheaper. But mine is just a personal machine for me to use around my yard. I would recommend switching the points over...
I was working on re-sealing my lift spool, and it would appear I was not the first person in there. When i was unscrewing the back cover it was under spring pressure (which didn't seem right). As it turns on whoever worked on it in the past lost the inner washer that holds the centering spring...
I have my motor out of my 742 to repair a leaky input shaft seal (it was brand new and is leaking, weird). While i have the motor out I was thinking about doing a little spool work. My left foot pedal does not recenter when you push on the back of it. I figure it is probably the centering spring...
My right swing cylinder is leaking on my backhoe. Is it possible to replace the seals without removing the backhoe? I’ve rebuilt some cylinders in the past but these are a whole different animal. I don’t see any gland nuts to remove.
That’s what it was. I reversed the lever and it worked. The previous owner replaced the two Supply lines before he sold it to me. I will just flip them around.
I picked up a really nice 909 backhoe for my 742. I just got the mounts for the skid steer worked out, and replaced all the backhoe hoses with new ones since they were worn. When I go to use it I only get little movements, and you can here the hydraulic pump make some noise. My right control on...
I am still looking for a set of backhoe mounts (trailer ball style) for a 743. I have been unable to find a set. I do happen to have a set for a 753 that someone passed off to me at 743. Thanks,