Concrete Braker ???

Help Support SkidSteer Forum:

RS Coyote

Well-known member
Joined
Apr 28, 2005
Messages
84
I just picked up a used concrete breaker from an auction for $350. I tried it out on a big rock out in front of my house. It hammers consistently but did not seem like the blows were hard enough. I've never used one of these before. Can someone describe to me what I should expect?
 

Mtn-man

Member
Joined
Apr 10, 2005
Messages
8
Check the nitrogen gas pressure. If it is low then it will hammer but there will be very little force. Hope this helps. Jay
 

bobbie-g

Well-known member
Joined
Mar 15, 2004
Messages
574
Check the nitrogen gas pressure. If it is low then it will hammer but there will be very little force. Hope this helps. Jay
I remember reading a couple of posts about a breaker here in this forum somewhere, in the past several months I believe. Seemed the breaker was vibrating the skid steer too much, and the cure was a nitrogen recharge. The post should be here somewhere. ---Bob
 

Mtn-man

Member
Joined
Apr 10, 2005
Messages
8
I remember reading a couple of posts about a breaker here in this forum somewhere, in the past several months I believe. Seemed the breaker was vibrating the skid steer too much, and the cure was a nitrogen recharge. The post should be here somewhere. ---Bob
Bob, That was my post. Called "Hydraulic Breaker is breaking my 873!". It was in the Skid Steers Forum on 5/1/05. Jay
 
Top