Hi all, this is my first post, I'm hoping it's in the right place. I have a rotary broom that doesn't have hydraulic assisted angle. As i'm sure anyone will agree, stopping the machine, getting out, kicking the broom around and getting back in again is not only a PITA, but lets face it, one of these times i'm going to trip and face plant on the broom..... So I'd like to add a cylinder to move the broom from the cab, same as I do with my plow. I have an 06 s205 with the 7 and the 14 pin connectors. Since the 7 pin is CAN-Bus, that will be out of the question. What I'd like to know is does anyone know the wiring pinouts for the connector so I can determine which control switch in the cab will run the angle? Any thoughts? help would be appreciated. Thanks.