Recent content by schreib

OK, as I understand this SR 80 hydraulics and Electrical: -- If you connect the Lo Flo hyd. lines to an attachment it makes a switch right there on the coupler and connects a line to ground that allows the Low flow AND HIGH FLOW power relays to send power out to their respective rocker switches...

Please help me locate the oil pressure sender. I can see two senders on the top right side of engine behind radiator. Figuring it is one of these.

OK. the grapple creeps CLOSED, jaws close from an upper open to lower closed position. I guess if what you are saying is fluid is leaking by an operating valve it could cause the jaw to open(UP, against gravity) This does not happen. However, I get your main point and will look over the fluid...

by auxiliary valve I am guessing that is a valve ON the loader not on the grapple. It appears the grapple hydraulics are nothing more than a couple of cylinders, hoses, and couplers. . . about switching the ends, not seeing how it can creep the other way because the creeping occurs because...

OK, I am another rookie here with a rookie question. I have not used this Notch tine grapple much but enough to notice that NOW it appears the top jaws(2) fall down(albeit slowly) when I have them opened to grasp stuff. I have to constantly watch them to be sure they are not going down when I am...

also, I have put a number of hours on it since and no problem at all.

after speaking with ASV / Telex tech guys, they agreed it is no problem. . . thanks for your input just the same.

I just changed it. Looking to remove the diesel oil sitting on top of hyd. oil with a suction tube. can't get the 1" plastic tube down the entry pipe. Looking for solutions in this way first.

I need to remove some hydraulic fluid from the top. . . Not really, but some diesel oil . . . I accidentally started feeding diesel into the wrong hole(right next to each other), stopped almost immediately. Probably only put a few ounces in(sight gauge went up 1/8"). I would like to remove the...

I need to remove some hydraulic fluid from the top. . . Not really, but some diesel oil . . . I accidentally started feeding diesel into the wrong hole(right next to each other), stopped almost immediately. Probably only put a few ounces in(sight gauge went up 1/8"). I would like to remove the...