One question I have: My machine has the third hydraulic spool, but doesn't have a pedal to operate it. does anyone have any pictures of what their third pedal looks like for operating this hydraulic set?
Heyall. I have a 1977 Bobcat 310. It was leaking hydraulic fluid, the best i could tell from the axles. Sooo I started the process of replacing axle seals/bearings. Along they way, I've discovered a few things, and this has rapidly turned from "make it stop leaking" to "full restoration". So...
I just bought a bobcat 310. it has a decent hydraulic fluid leak. i need to fix that. As I've been looking into it, i see these machines are rated to use motor oils for hydraulics, 10W40 or 5W20 looks like a good candidate for my cold area. The manual says hydraulic fluid isn't approved...
I just bought a 310. Thanks for replying to my post earlier. I'm living the same dream a few steps behind... any pics/notes you're willing to post will be eagerly viewed!
You just rewired your 310? I've been doing that over the last couple of days. I got it finished, seemed to run ok, but i have a couple gremlins. I'm not sure i have the high/low speed wiring correct. I have the high speed swtich grounding out the field side of the relay. on the load side, i have...
I need to make up some new connectors. one for the regulator/rectifier, and one for the clutch speed relay. Anyone know where a fella can get replacement connectors with the appropriate spade pins? i found a regulator one online but it doesnt come with the pins.
Hey, I have a bobcat 310 I'd like to add some led lighting to. The unit has a Koehler k341 engine. Does anyone know what this engine generates for charging amperage? I'd like to be in a situation where I don't rundown the batt very by running too many lights. Would like to know what the net...
Hey there. I'm in northern WI and I just bought a clark bobcat 310 with a serial number of 4996-M-11341 at least thats all i can make of the serial number. I've not even picked it up yet, bought it on auction, so I'm just getting started on my learning curve. I'd like to learn as much about this...