Recent content by larryb346

More information I checked the ohms on the lift tilt lock out solenoid. It is 6 ohms . I had voltage coming to the connector but was less that 12 volts. I cant help but think the issue is connected with battery replacement or is a huge coincidence the battery would go dead and the tilt stop...

Yes sir Put in new battery full battery voltage. Pushed the push to operate button and the 4 light's normally come on. however the tilt/lift light does not. I have the analog gauges with key switch so not the fancy diagnostic screen. Push and hold headlight button and the word none appears so no...

Bobcat has been sitting for about a month. I tried to start it battery dead. Tried to use jumper box still no start. Replaced battery with new one. Had to change routing of battery cables slightly but everything hooked up. Started right up. Lowered the bar and the bar light came on. Pushed the...

Unable to edit and add this to the past post. I have the temp. gauge on the upper panel on the left side. The temp light I am referring to is on the right panel. Is this a engine temp light or a hydo. fluid temp light

Is the sender for the gauge and the one for the light different or does the gauge one trigger the light after a certain temp. The gauge just started into the red and the light came on. Within a few seconds of my stopping forward movement the temp started dropping and in 2 minutes of fast idling...

I totally agree it is the Hyd. causing the engine temperature to rise. I did not work the boom/tilt hyd. hard at all. I scraped some washed gravel and moved it back where it had washed from. Total likely no more than what would be a full bucket. Prior to that I scraped some manure out of a barn...

There is very little debris. I will clean it out today but doubt if a cup full total. I drove it about 1/4 mile and the temp went from cold start to normal. After that I moved some gravel that had washed in recent rains and it was still normal temp. I drove it maybe another 3/8 of a mile and it...

I have a 2001 763G. It runs great. After using it for 30 minutes or so in 90 degree weather it starts getting hot. The temp gauge goes to the yellow and approaches the red. Today it did get nearly to the red and the temp light came on. I can let it idle or run for a few minutes without using the...

Still dealing with this issue. I checked all the fuses and found a fuse labeled ALt/kits blown. I replaced it and the foot pedals started working they worked for 10 min or so then blew the fuse again. I can put a test light on the fuse and when I wiggle the fuse the light will flicker indicating...

I have never heard a beep. I need to check that also. I was operating it and bounced it over some sticks as I was pushing some limbs and the ahc or what ever it is light came on and the loader stopped working. There was no beeping just stopped. I restarted it and it was fine. I don't know if...

There is no noise period. I push the switch and only noise is the switch moving. I have been pushing the press to operate button again after switching. It is like the only power coming to the switch is the top light wire. I checked all the wires and it is the only one with power no matter the...

The switch is lit at the top when I change the switch to the lower position the light does not change to the lower area of the switch. The only power to the switch no matter position is the top power to the light.

The tilt and boom work fine with the hand controls. The foot pedals are locked solid. When I try to change back to the foot mode there is no noise to even indicate the switch position has been changed.

It is currently in the hand control mode

I just bought a 2001 763. I tried it out before purchasing and I was able to change from the foot control to hand control for the bucket without issue. Bobcat dealer replaced a leaking throttle plate and drained and refilled the chain cases. I didn't retry the controls. After I got it home it...