I just bought a 2001 763. I tried it out before purchasing and I was able to change from the foot control to hand control for the bucket without issue. Bobcat dealer replaced a leaking throttle plate and drained and refilled the chain cases. I didn't retry the controls. After I got it home it will not switch from hand to foot pedals. I checked the fuse and it has power on both legs so it is good. I pulled down the panel and checked the switch. It has power on one wire and it is for the illumination bulb,which is lit. I looked to see if sometime came unplugged while bobcat was working on it but do not see anything obvious. The only way to switch that I can think of would be to have power to the switch beside the bulb leg. I tried switching and then re-pushing the operate button . I also switched with the key off and restarted and no change. Any suggestions would be appreciated. There are no codes showing when checked by pressing the light switch. Thanks Larry