Recent content by Heetseeker

I purchased my 843 with the 911 backhoe attachment and rarely used it, except turning up my garden a couple times each year. Got stuck several times and sold that and purchased a 3 ton excavator for that job and others. Pretty happy with that switch.

Fuses were fine and I picked up two new fuse holders as the other two were a little corroded. Also replaced both start and glow plug relays. Fires right up and runs great. Turned out to be the start solenoid. Thanks for the help!

Didn't consider a fuse or connection. I'll check it this morning. Thanks!

I've searched these forums and ran a couple tests, but here's the issue: Click, no start. New battery, cables, charged and new alternator, all tested out good. With a meter, the wire coming from the key switch (white) goes from 0-2.4volts when I turn the key to start. No power, to only 2.4 volts...

I mix the paint with acetone, not thinner. It dries very fast.

Wilton CA 95693

thanks for the info...i'll look for that door part on iron planet. Good to know about the battery as well. I found a picture of the door latch finally. i'll keep looking for the parts. cheers!

That's great news! i'll pop the ROPS back and take a look. If I can tap into that control valve, i'll have to find a hydraulics diagram to guide me through the process. I'll try and find some bobcat stabilizers or consider making a set. Thanks for responding back!

843 with front aux hydraulics that I can run my backhoe with, but want a little more down pressure for the Hydraulic auger i'm going to be attaching soon. What's needed to add auxiliary hydraulic connections for the rear of this machine? I can build the rams and mounts.. Thanks!

843 with isuzu motor. Came with a smooth bucket and 911 backhoe. Repaired the seat bar, replaced the seat and alternator. So far, a powerful and handy machine. Looking to make a heavy duty attachment plate for my auger, then a fork attachment. If I can get a plane done for the driveway, i'll...

I just picked up an 843 and have been cleaning it up and inspecting the electrical. I also found 2 spade connectors (one was hot) and a black ground wire just hanging under the seat area. I'll be trouble shooting the charging system and see where these go soon.. I've ordered a complete manual...

Just purchased an 843 and i'm getting things back to working order.. New to the skid steer machines and can't seem to find pictures of what the back door latch system is supposed to look like. I'll fabricate something but don't want to reinvent the wheel if members have a better solution for...