Recent content by coreya3212

Hello all. I have a Bobcat 337 mini excavator. The thumb cylinder has a fitting that the hose broke off. So the hose end with a female JIC has a chunk of the fitting off the cylinder still threaded onto it. The fitting is a square looking thing with what look like a allen recessed plug to...

Yea mine had 3 holes and we think the v20 had four. The manual shows 3 holes and thats why we figured I would have needed the whole new set up. The back pressure excuse from those clowns was complete Horsesh!t as confirmed by several here and my own extra day of screwin around. The guy told...

Hopefully to put this thread to rest finally. I had no luck sourcing a segment for the valve. the best hyd shop, by best I mean gave a crap and was trying to help me, thought that it would likely be a valve manufactured only for Bobcat and they would not be able to sell me a section direct any...

What comes in the hyd aux kit? Tazz is right on the steel lines. In Calgary, we have a place called Green Line hose and fittings and they will do a steel line while you wait. For the lines that is what I would do. They are about half inch lines, same as the ones already routed off the hyd...

Lapped it today. Wasnt warped at all and no hi spots. And no seal. Gonna price out a new valve segment tomorrow and hope for the best. Thanks all.

Depends on the part I suppose, as Tazz said. I own a 825 and have been able to order everything I have needed from Bobcat, but they are a last resort. Seals I take to transmission shop and have them measured, way cheaper. Stuff like that. But Bobcat has never said they couldnt get a part in...

Thanks Fellas. Those pics are not mine Fish. Mine are in the folder “ Corey Shop Build” last 3 pics. Nothin to see really, just the diagram of the valve from the service manual. I think I gonna try lapping the bad side to see any deformity. I have inspected it under a magnifying lamp and...

http://www.skidsteerforum.com/DesktopDefault.aspx?tabid=54&frmView=ShowPost&PostID=35497 I dont have a 763 or hand controls, but I have read of people having this porblem before. This thread may help you, or try searching aux hydraulic controls. Good Luck.

Rich, I am in a simialr situation. Not do to head room, but my old 825 has no lock bar, maybe they never did when this old girl was built. I raised the arms and have a 2x4 wedged in there under the arm and sitting inside on the frame. As a redundant catch, I had a piece of steel tubing, so I...

I have a feeling you are looking at pictures other than mine. What gallery were you looking in and I will see if thats the same as mine. The pictures I uploaed were black and white out of the manual so you wouldnt have seen colors of the seals. This leak does not have anything to do with the...

Sooooo...from everything that has transpired thus far, i should assume they used the wrong o rings.

Uploaded Hyd schematic, and a page that shows the valve itself. In the media section in the photo album titled Corey Shop Build. Last 3 downloads,

It is leaking between segments. Between the inlet and the first valve segment. I dont know what a compensated valve is, so I dont know if I have one. Sorry Fish. Everything functions properly, just that it leaks and doesnt seem to be cured with new o rings. The shop looked up the valve bank...