Recent content by antiquejohndeere

I started getting an engine low oil pressure alarm on my 1999 873 withd the deutz bf4m1011f engine. So I immediately removed the sender and installed a gauge. It showed no oil pressure no matter what rpm it's running. I have checked to make sure the timing by is turning the oil pump and it is...

I'm fixing to change oil on my 1999 model 873. Last year when I drained the engine oil it seemed like it didn't drain no where near the amount that the owner's manual said it holds. Am I crazy or is there somewhere else I need to drain to get all of the used oil out? Also what is the gpm of the...

I was just trying to figure out what it was rated due to buying different attachments.

I know the bobcat history website says 18.7 gpm for Hi-flow and n/a for standard flow. My machine doesn't say hi flow on it anywhere. Does that mean it still it still is 18.7 gpm. Thanks

Does anybody no what the gpm of the auxillary hydraulic system is for a 1999 873F without high flow. What is the relief pressure also? Thanks

I have a 1999 873 F-series. When you turn the key off it won't shut down. The only way to kill it is to turn the key all the way to the left which bogs the motor down to kill it since this is for relieving the aux. pressure lines when the engine is off. We've been getting off and opening the...

I am getting the injectors checked on my 1999 873. What is the torque for the hold down clamp bolts when reinstalling the injectors? These are the bolts with the external torx heads. Thanks

I am having the injectors reworked on my 1999 873 bobcat. Does anybody know what the torque spec is for the hold down clamps on the injectors? Any installation tips would be helpful, but it seems pretty straightforward. Thanks in advance for any help.

I have a 1999 873 with 1450 hrs. It has the deutz engine. While picking up some parts @ the dealer, I went ahead and got a timing belt kit. What is the recommended time interval for changing the belt? I have access to the 2 timing pins I need to lock down the pulleys. Does anybody have a...

I appreciate the reply, but I don't know if that is gonna work on this valve. The seal is back inside the hole about 1". The hole to the outside of the valve is only a few thousandths bigger than the spoolpiece. I tried to push a new seal back threw the hole before taking the old seal out. You...

I have a Bobcat 873F. Yesterday oil started leaking out of the tilt spool of the control valve on the spring end. I unhooked the linkage and took the 2 allen head screws out of the cap and pulled the spool piece out. The seal is orange in color and was damaged and I'm going to replace it. My...