Hello Everyone,
I was using my bobcat the other day, and noticed metal filings coming from the pivot pin and bushings on the bobtach. Further investigation showed a great deal of wear on the pin, and the bushings are all wallered out. There were never any grease fittings on this piece, and because of that, I guess I did not pay enough attention. I have looked in the parts manual, and it is not clear to me if I can get replacement bushings from Bobcat, or do I need to make my own? I have done a search on the forum, but could not find answers to my questions. The pin I can determine the part#, but I am not sure on the weld in bushings. If they do not come with grease fittings, they will have them when I am done so I do not have this problem again. Any help would be greatly appreciated.
I was using my bobcat the other day, and noticed metal filings coming from the pivot pin and bushings on the bobtach. Further investigation showed a great deal of wear on the pin, and the bushings are all wallered out. There were never any grease fittings on this piece, and because of that, I guess I did not pay enough attention. I have looked in the parts manual, and it is not clear to me if I can get replacement bushings from Bobcat, or do I need to make my own? I have done a search on the forum, but could not find answers to my questions. The pin I can determine the part#, but I am not sure on the weld in bushings. If they do not come with grease fittings, they will have them when I am done so I do not have this problem again. Any help would be greatly appreciated.