I bought a brand new Wolverine sickle bar mower at an auction. I finally got around to trying to set it up and ran into a problem. Everything went on my skid fine the blades are working as they should but the sickle arm lift ram is not working.
The thing came with no instructions but has an electric switch that gets mounted in the skid cab and sends A 12v charge to a servo on the ram to lift or lower the bar. I am getting 12+ volts at the wires where I attach to the servo but no action on the mixing server.
Can anyone suggest what I should be trying to troubleshoot from here? And I can't intuitively figure out how that mixer is supposed to work.
I contacted Wolverine but they have not been very helpful so far. Any help appreciated.
The thing came with no instructions but has an electric switch that gets mounted in the skid cab and sends A 12v charge to a servo on the ram to lift or lower the bar. I am getting 12+ volts at the wires where I attach to the servo but no action on the mixing server.
Can anyone suggest what I should be trying to troubleshoot from here? And I can't intuitively figure out how that mixer is supposed to work.
I contacted Wolverine but they have not been very helpful so far. Any help appreciated.