Golden Gate
Active member
- Joined
- Jun 18, 2011
- Messages
- 37
Well here I go again, y'all may remember I had just replaced the two tapers and bolts on my 185 used less then 20hrs since taper replacement and the bolt broke on the 1 side yet again. I have yet to tear it apart, I am hoping the taper at least is not broken. I was using a grapple on some brush at the house no strenious lifting. When put back together there was no slop etc and I did replace both sides with all new parts and every time I get on the machine I check the bolts on both sides. Does anyone have a clue as to what is going on? Is it possible I've gotten a bad bolt direct from bobcat?