Dirtballer
Member
- Joined
- Nov 15, 2019
- Messages
- 13
Just put a new head gasket on machine - did not disconnect any wiring (except two sensors on block). At one point, my wrench hit the live-wired solenoid when installing the injector at the front of the engine, but I don't understand how that could cause a problem. Had no problems starting/running prior to taking head off.
In run mode, solenoid behind seat just clicks. Starts and runs properly in service mode. Had blown 5A EIC fuse - replaced.
Can anyone provide a quick answer on how to jump/eliminate the seat/seat belt switches if I undo the connector in the engine compartment, as I think this is the problem?
Thank you for any assistance anyone might offer.
In run mode, solenoid behind seat just clicks. Starts and runs properly in service mode. Had blown 5A EIC fuse - replaced.
Can anyone provide a quick answer on how to jump/eliminate the seat/seat belt switches if I undo the connector in the engine compartment, as I think this is the problem?
Thank you for any assistance anyone might offer.