Hi guys. I own an S250 in a remote location in Mexico. A few weeks ago, I replaced the gear pump because it was lacking pressure. I disassembled the gear pump and it was in a really bad shape inside, so I ordered a new one from my dearest dealer (a 7 hour drive). After spending my yearly allowance (really, it was super expensive), I installed the new pump, but when I start the machine it beeps after a couple of seconds and the top extreme right light comes on and then a continuous beep starts and then the whole bobcat shuts down Before it shuts down, it idles for about a minute, but it won´t move at all. It remains locked. The code it shows is 01-16 and then the word Shtdn 62.1 I am hitting a dead end here and I thought someone would help me to decipher this. Can I erase the codes manually out on the field without any special tool? Any ideas? Remember my nearest dealer is several hundred miles (and dollars) away. I was hoping I could fix this myself. I really appreciate your help gentlemen mauricio from Mexico
