Case 1835 Will Start but will not Continue to Run?

[redcheetah]

I have a Case 1835 Skid Steer. I start the skid and it starts well but within 3-7 seconds it will die. I have checked and cleared all fuel lines, checked the fittings that go into the fuel pump and changed the fuel filters. There is also pressure in all junctions between the tank and the pump that I am aware of. I am out of reasons why the skid will not stay running and eagerly await any suggestions from the board here. Is there any chance that the pump is no good or that the rig is simply too low on fuel (I can't tell the fuel level on the skid). Thanks

 

[Tazza]

is it possible the fuel shut off solenoid is not holding?
Usually the ones with an electric shut off have a timer on the solenoid. The pull coil pulls the plunger back and holds it there for a set amount of time. It then releases letting the hold coil hold it in place. If the hold coil is bad, it will simply snap back and shut down.
When it stalls, does it do it slowly or just a straight out stop?