Bob-tach bent

Help Support SkidSteer Forum:

andyjax

Active member
Joined
Jan 4, 2012
Messages
32
One of my 773 g bob-tach attachment plates looks like it's bent. Hard but not impossible to hook up any bucket. Anyone out there know the best way to bend it back straight? I'm assuming the plate should be in a straight line with the other side. Do I need to take the bob-tach off? It's the manual type-not hydraulic hookup. Thanks.
 

farmshop

Well-known member
Joined
Mar 27, 2014
Messages
698
If it's the top piece that is bent usually a big sledgehammer can get them back into place
 
OP
OP
A

andyjax

Active member
Joined
Jan 4, 2012
Messages
32
If it's the top piece that is bent usually a big sledgehammer can get them back into place
It's the 'plate' on top that hooks into the implement. I made some progress yesterday by putting the weight of the front end on the spot. It moved a good bit. I'll try the hammer technique for the fine tuning. Thanks. Just didn't want to harm the tilt cylinder on that side.
 

Latest posts

Top