Farlsincharge
Member
- Joined
- Sep 25, 2013
- Messages
- 15
Trying to use a grader attachment on my s185 without pilot controls. I hook up my auxilary hoses and my 7 pin electrical connector. Engage maximum flow. The two small vertical toggles on each of my control sticks work to run each side of the moldboard up and down. However, the left hand center toggle only runs the rotate in one direction no matter which way it is pushed. I think it is operating the solenoids correctly, however when it is pushed to the left I think it is reversing hydraulic flow. That's why it will only extend the cylinder, not retract. Anyone have experience using all three switches to run an attachment?
