775 nh firing order ??

[papow22]

My nh 775 is a v-4 gas west conn. approx 65 hp.It has electronic points.Something happen to my nh the coil slid out enough to pull unplug the wires ,so I replug the wires must have goofed up cause the elec points started to smoke.So now I have to find some imfo on the wire diagram for the dist & coil.Is there anyone that have any imfo on the wire diagram.Anything would be greatly appriciated.

 

[rskybizintrees]

You can see it here just pick your model. http://www.messicks.com/cnhmodels/skidloaders.aspx I have one and am looking for info regarding lift cylinder and spool valve, I replaced seals in the lift cyl and took out the valve bank/spool valvedid all new orings and nor bucket still works fine but I can not get the lift cyl to move, appered to want to then No go. wanted to ask if I need to cycle them manualy suckiong fluid as I go or will they self prime?

 

[papow22]

You can see it here just pick your model. http://www.messicks.com/cnhmodels/skidloaders.aspx I have one and am looking for info regarding lift cylinder and spool valve, I replaced seals in the lift cyl and took out the valve bank/spool valvedid all new orings and nor bucket still works fine but I can not get the lift cyl to move, appered to want to then No go. wanted to ask if I need to cycle them manualy suckiong fluid as I go or will they self prime?

Gee whiz,I just wish I knew that one.But sadly to say I'm buffaloed on that primeing part,But if I should find the answer I'll post a reply to you , rskybizintrees. P.s. I'd give the priming a try ,I don't it would hurt .???.

 

[papow22]

Gee whiz,I just wish I knew that one.But sadly to say I'm buffaloed on that primeing part,But if I should find the answer I'll post a reply to you , rskybizintrees. P.s. I'd give the priming a try ,I don't it would hurt .???.

Sorry about that I was so excited I forgot to say thanks to imfo on parts place for the L775.I'll keep on asking around about the problem you have,I post it when I get a answer.thanks

 

[rskybizintrees]

Sorry about that I was so excited I forgot to say thanks to imfo on parts place for the L775.I'll keep on asking around about the problem you have,I post it when I get a answer.thanks

got my hyd figured out! did Messicks show you what you needed? if not Ill get it for ya as I know its around, my wisper chipper had the gas motor may even have a shop manual for it. keep me posted we can trade issues/ problems a chance for both to benifit! rsky

 

[papow22]

got my hyd figured out! did Messicks show you what you needed? if not Ill get it for ya as I know its around, my wisper chipper had the gas motor may even have a shop manual for it. keep me posted we can trade issues/ problems a chance for both to benifit! rsky

Sorry for taking so long to reply,but messicks didn't have none but thank anyways.Sure would be if you could find how the wires hook up to the coil & dist.Rite now I'm home once in awhile for I driving in oil patch this winter so I'll try to check in when I'm at the puter thanks Gord.