Looking for some guidance if possible, I'm 99% sure my fuel sender is bad. Registers full after fueling, drops off to empty and throws idiot light on after 5-6 hours of runtime.
I flipped the cab, took off right side access plate by lift cylinder. I can see where the fuel fill hose drops below and into the tank by hydraulic lines. For the life of me I can not see an electrical connector, harness takeoff that is for the sender anywhere. I read online that tank removal requires pulling the engine and main pump - hoping you don't have to do that to change the sender...
Do I have to remove muffler, fan, fan shroud or get at it from the left hand side access? Or from the lower access panels around the axles?
I would appreciate some assistance, I don't really have the scratch to take it to the dealer at the moment unfortunately.
I flipped the cab, took off right side access plate by lift cylinder. I can see where the fuel fill hose drops below and into the tank by hydraulic lines. For the life of me I can not see an electrical connector, harness takeoff that is for the sender anywhere. I read online that tank removal requires pulling the engine and main pump - hoping you don't have to do that to change the sender...
Do I have to remove muffler, fan, fan shroud or get at it from the left hand side access? Or from the lower access panels around the axles?
I would appreciate some assistance, I don't really have the scratch to take it to the dealer at the moment unfortunately.