The previous owner removed them and connected the two flexible lines together. I'm looking to replace them but can't figure out the part numbers. Messicks diagrams are pretty good, but I can not find them referenced anywhere. Also wondering if I could find some used parts, or if I can get away with just replacing them with flexible hoses and off the shelf couplers? I could fabricate a bracket... Any ideas?
Help Support SkidSteer Forum:
USA. Mountains of Tennessee. Thanks for helping me with this. I got lost in the diagram.
-Terry
PS: Standard Flow ( 2,500 PSI 12 GPM. I think, would hate to get that wrong). If I can't find a used set I'll see if I have room between the cab and the boom to just run lines.
That sounds right for a standard flow.
NH LX865, LX885, LS180 and Deere 8875 should all be the same here. And I bet you could make tubes work from NH LS180.B, LS185.B, and L185 also.
I see Worthington Ag Parts have salvaged units listed in other parts of the country, but not really near you. Would have to talk to them about cost.
NH LX865, LX885, LS180 and Deere 8875 should all be the same here. And I bet you could make tubes work from NH LS180.B, LS185.B, and L185 also.
I see Worthington Ag Parts have salvaged units listed in other parts of the country, but not really near you. Would have to talk to them about cost.
