Recent content by wirenut

Thanks for your response. Could you explain tying into the auxiliary’s and pumping some out using the loader??

Haven’t used my 2044 for about a year. Its in a garage all the time. Over the winter I changed the air, oil and fuel filters. I also changed the oil. I checked the Hydraulic oil and it didn’t show up on the dipstick. I got a gallon of Hy-gard and it took the whole gallon before it showed up...

hey, rookie, thanks.......I got them off with an impact gun.......you're right....they put locktite on the bolts.......anti seize is a good idea.....will do that next time I take off......I took the cover off and cleaned all out under it......was ridiculous.......you are right about light coat...

hey, thanks for responding.....sounds like the same problem.......did you take the actual foot pedal off? I have 2 bolts right in the middle of the pedal itself.....if that came off It would be a lot easier to get in there with shop vac and long screwdriver to clean out around...

has anybody taken the foot pedals off? I have a lot of mud down under the pedals I want to clean out, Tried to take the two bolts out and they are really tight, couldn't break loose with a regular socket (not enough leverage) and didn't want to mess something up! Can I use and impact gun on...

can anybody tell me why, when the bar is down and seat belt on and both indicator lights red, my 2044 starts and then stalls out..........this happens repetitively........I went out to use the machine, it started fine. Ran the machine. shut it off and when I went to start it it kicked over, then...

it has under 300 hrs on it...........I wouldn't think there would be linkage wear yet would there?....I jacked it up and checked play in each wheel 1 side at a time......and it was tight and equal.....in order to check do both wheels on the side need to be off the ground? I put floor jack...

thanks for getting back rookie........I will check the manual........how are you making out with your unit? It has rained so much and my property is so wet, haven't been able to play yet.......have a huge pile to move from back to front........still trying to learn how to operate my...

hey tazza, with regard to this problem my 2044 (I just got) on black top occasionally starts hopping on a turning radius........is that inexperience with the controls or is there a timing problem.......

hey land tech....what are the 2 rockers for and which did u say for the auxillary hyds?

hey guys does it matter where you put the primer bulb? Ken did you say up in the cab? is it possible to have too much line?

hey tazza, could you further explain yourself? Just bought a 2044........whats the best way to jack up so all four are off the ground.........any bad places to place a floor jack and stands? thanks for helping a greenhorn

hey rookie, good question......I have the same question and the same predicament......looking at the design the way the OTT fits over the 2 tires it doesn't look like it matters how much tread is on them........unless the inside of the tack has to grip on good tread, but the way it boxes over on...

hi guys......is there any way to adjust the throw on the foot controls......left control, the angle on the foot control is such that I can't seem to pivot my foot and keep good steady control.......right one seems a little better.......is this just because I am right handed and have better...