hi,
a friend of mine is looking an a clark era m700 with no drive on the left hand side. it sounds like the whole left side is freewheeling. I'm inclined to think it is a broken drive chain but to be honest I don't know much about m700s. do they have a common chain for the front and...
I just resealed the control spool on my 743 and had a similar problem. Couldn't get boom or tilt to move much. Try cycling your aux hydraulics by shifting the right stick left and right. I think air gets trapped in the lower portion of the spool and it airlocks the spool. I did it on mine with...
If it's anything like a 743 then it is the aux hydraulics. Could be quad rings which can be done in place or could be a hose or boss ring which may involve yanking the boiler.
Oh crap, I made a mistake. Resealed the spool valve but in the process I mixed all the spools up. I didn't realize that there were different part numbers for the spools. Gotta rip it apart again and see if I can figure it out.
Got quad rings from a hydro shop for the whopping price of .87 each. For future reference if anybody reads this thread the vickers pump inlet seal dimensions are: 1.75 OD, 1" ID and .300" thick. Pump is a vickers ta1919v10r I used a $20 2 jaw puller to get the splines off the shaft. I also...
Thanks for the info. I got the spool block put today and now she's soaking in the solvent tank. I'll pop the quad rings in the AM. The leak ended up being the spool return hose off the bottom of the block like you suggested. My aux hard lines aren't exactly looking great either, I'm going to...
hello again folks. engine is pulled on my 743 and im still looking for the mystery leak. i think its the spool return line but i havent got it out yet. anyways im going to do some preemptive maintenance while in in there. i want to reseal my control spool. it looks like i need quad rings and the...
I pulled the engine on my 743 today to find a leak and noticed the 2 capped off hard lines near the air filter are on their own spool which isn't hooked up to any control lever. What was the idea behind this?
Hey guys, Theres a pretty good leak coming from somewhere down deep in my 743. I think the control spool might be leaking or one of the hard lines for the aux hydraulics rotted through. At any rate it looks like I'm pulling the engine to get it repaired. I'm an HD mechanic for a living with a...
I built a wood splitter for my 743 and when I run the aux spool something on the bottom side of the aux valve leaks. Aside from obvious o rings and hoses is there anything common that would possibly be leaking? This machine sat for a very long time so I'm assuming that it's probably something...
Hey folks. The pull know broke off my shutoff cable and ita getting pretty sticky for that matter. Has anybody upgraded to an electric shutoff solenoid? I see Amazon has one listed for a 743/v1702 but I'm guessing it requires a different bracket then the mechanical shutoff. Before I start...
Anybody put a shutoff solenoid on their 743 with a v1702 Kubota? My shutoff cable is getting awfully sticky and the know broke off so it's a vice grip affair now. I also always forget to turn the key off after pulling the shutoff. Anyhow anybody put an ignition controlled solenoid on there? I...