Recent content by smoorebuck

I removed the connector going to the sensor and then started the machine checked the panel the alarm was still there. The gauge reads empty. I got a mess now i was removing the fuel level unit from the plastic fuel tank. And the aluminum insert that the unit screws into came loose from the tank...

Tazza great call replaced sensor trouble cleared. I have one more code 9 21 and my dynostics on my machine reads fuel level high out of range. Do you have any ideas on this one. Thanks for all the help.

My old new to me machine bob-tach is missing the atachement lockdown arms and hardware. The only thing left is the verticle wedge pins. Does any one have any exsperince in repairing these to like new condition. I also have a lot of play in the bucket piviting arms. Does these have bushings that...

I fownd a loose ground wire on my charge filter. Repaired this and it cleared the charge filter plug error message. I still have a hydraulic high temp message. It has hydraulic fluid in the machine. The cooler is clean and the hoses appear to not be exsesively hot. Any ideas? as always thinks...

It has been in the 30 to 40 degree area since i have been looking into this.

My machine is saying that my hydraulic charge filter is plugged. Does any one no where this located and can it be cleaned or do i need a replacement filter. As always thanks for any help.

The pickup tube is a bear to get to I have no skin on my upper arm a bruises to prove it. It was cloged up. Someone has worked on it in the past. They used a piece of brake line brazed to the fitting. I cleaned it and reinstalled it. When i started the machine the pump bulb went flat but never...

Thanks for the help. I think i got two problems one being the high temp on the hydraulics. I did find today that the hydraulic fluid was overfilled. The 2nd thing was the machine shuting down the machine was missing the fuel pump bulb i installed one today and when it shut down the bulb goes...

What would be the fix for this problem. The reason i asked about the fuses is the lights are not working. The unit has 3000 hrs. on it. I only paid $1500.00 for it and it passed the stol;en machine check. I have several little things that needs attention. So all your help is apreciated very much.

Thanks for the input the machine is showing a code of 7 21. The cooler is operating properly. do you know what this code is. Also do you know where the fuse panel is located? Thanks

unit looses power and shuts down. restarts and powers up then reapets. computer reads hydraulic oil high temp and fuel level high. any ideas machine has been seting outside for about a year before i bought it. Any help would be appreciated. Thanks