Recent content by rumrunner

I was experimenting with it a little more today, left or right pedal gets the same reaction.

On my S185 two speed machine, when the hydraulics are not engaged and I move the left foot pedal it seems to cause the hydraulic wedges to engage or disengage! What is the connection? Also, with the hydraulics engaged, if I hold the wedge switch up or down and move the foot pedal I can cause the...

Other than esthetics I don't think it matter which way the tire is mounted. Think about it, you probably go backwards as much as you go forward. It is more important that the amount of tread on each side tire is similar. You don't want an old worn tire on the front and a new tire on the back or...

Any comments, good or bad on the SR 200. I am thinking of getting one. One comment I heard was that there have been electrical issues with the newer CASE units. Apparently these issues get resolved in the field during the first few hundred hours.

One side was very tight, the other side had a tad of movement. Does one have to get a hone with the correct angle to do that?

Thanks to all.. It is all back together..new bushings pins and seals. Like a new machine.

TAZZA- and Bobcatdan- Thank you I have the unit all apart, the left side is good, real tight fit on the pin and the bushing. The right side is a different story, the bushing is cracked and the pin has at least a 1/32nd of play in it. The next question is how do you get the bushing out of the...

Is the bushing-with the pin and threads pressed into the attachment plate housing? How is it held in there? Other than the grease nipple there are no bolts or anything that I can see to hold anything in place. Or is the housing machined with threads?

Ok..so this "pin" that you pull into the lift arm - how do you do that? I guess what I would like to do is take the entire plate off of the lift arm so I can see what is going on. But as you say there is a pin that is holding the good side in place-do I just tap that pin back with a smaller size...

One of my tilt plate bolts fell out today.. Where the tilt plate attaches to the lift arm. I put the unit in the shop and checked it out, compared it to the other side. It would appear that there is some sort of bushing in the tilt plate assembly that the bolts threads into. This is missing on...

One of my tilt plate bolts fell out today.. I put the unit in the shop and checked it out, compared it to the other side. It would appear that there is some sort of bushing in the tilt plate assembly that the bolts threads into. This is missing on the side that the bolt fell out of. What do I...

I am driving out to Abbotsford in the spring. I will probably go to Bellingham, so will have one of those windshields sent there for pick-up. Let me know if you want one, I will probably drive back via Hwy 16/37..been through Telkwa many times. Drop me an email at [email protected]

http://www.ebay.com/itm/6729776-6717360-New-Bobcat-Skidsteer-Tinted-Door-Glass-A220-S175-S185-T190-883-/230717430228?pt=LH_DefaultDomain_0&hash=item35b7d499d4 Shipped via USPS for $113.00 Makes for a good deal! I am in Yukon, where are you? Maybe we could get two shipped for a better price.

E-bay has glass replacements for a reasonable price - http://www.ebay.com/itm/Bobcat-Skidsteer-Door-Glass-S175-S185-6717360-6729776-/180788807553?pt=LH_DefaultDomain_0&hash=item2a17da4781

Sorry the post above is all run together. I typed it out line by line - but it came out as one paragraph