Recent content by Roscoe294

Thank You

Hey guys I have looked and cant find my answer so I figured I'd ask here instead of calling the dealer. Can someone please tell me the auxiliary flow rate of a 2002 Bobcat S250? I know its a 20GPM machine and I'm wondering if auxiliary is same or less? Machine does not have HI FLOW. Thank you.

2002 Bobcat S250 3400 hrs Hello, I need some help please. Had a bad tilt actuator (with error codes) and replaced it. Now after manual calibration, everything works fine except for the bucket curl. After dumping and when curling the bucket back under full pedal pressure it shudders. It returns...

Finally got error code of 32-31 Tilt actuator?

2002 Bobcat S250 3400 HRS Hello, Occasionally (once every couple hours) when operating, machine will beep, ACS light illuminates and hydraulics lock. Turn machine off and restart, problem gone........until recently. Same thing happens and after restarting, tilt will not function right away...

Are these Bobcat Lap Bars adjustable? Too provide more room under the bar? Say if the operator was on the heavy side and needed more room, still allowing engagement of the controls. There has got to be a way to modify this set up. Yeah? No?

If its anything like my JD7775 which I believe it is.........there are two areas to check oil. One would be between the drive wheels of the machine on the outside. You will see a plug with 1/2" drive recessed hole. Loosen the plug with a ratchet and remove. Stick your finger in the hole and you...

The front covers for the foot pedal clean out. If I'm operating in conditions where debris will not enter the exposed holes do I really need them? Just seems with them off debris from the top will fall through and not accumulate.

Sounds like your talking about your hyd control valve? If it is, you will need new seals. Seals are cheap but job is labor intensive.

Pedals were rusted into place. After a lot of lube I got them working again. I know have my ACS restored.

I've found with this forum and many others there is great knowledge to be learned. That's why I posted the thread as opposed to asking the dealer, which usually results in getting the worst case scenario answer first. Followed by being talked to like I should be a BC technician. There is NO code...

I've looked at past threads about ACS and could not find the answer to my problem. I have a 2002 S250 that has been operated solely by hand controls for over 10 years. I want to switch to foot pedals but when I do I cannot get the pedals to unlock. With the machine running, seat bar down, and in...

Scroll down the forum page and look for Mike10 in the NEW HOLLAND forum.

Might want to try the CASE forum. Scroll down the forum page.

One thing that pisses me off is when people get on here and ask questions about their problems and once answered they never update to say what exactly the problem was and what exactly the fix was. So here is an update on my leaky valve. THANK YOU Tazza!!!!! My mechanic changed the seals and...