Recent content by redfish1

Thanks, I will give that I try.

I have a new aftermarket temp. gauge that I was going to put in an old bronco and was wondering if it would work in my 1998 751 with a Kubota motor. My factory one is not working

I have put a lot of hours on it since I packed put the new seals in and it has not started leaking anymore and there is pipe wrench marks all the way around it. If it starts leaking again, I will repack it and I will put a new nut on it

Thanks, I am going to try it again tonight with a bigger sledge hammer.

I did that exact thing but I must not have hit it hard enough. I was afraid I might screw up the thread in the pins. I will try it again but will smack the piss out of it.

Thanks for the idea but can I ask how to get the pin back out. I must have really got down on it when I was tightening it up

That's a good idea. I have a sheet of some 1/2" hard plastic that would work perfect. Thanks for the idea

I have a 751 and put new pivot pins and bushings in the bobtach and have the bolts real tight and the bobtach still moves side to side a lot. Is there any way to get all of play out of it. I have heard where some people put washer on the pins to take up a some of the slack. Could it be that the...

Thanks for all of the help. I did finally get it apart an put the new seals in and got it all back together and ran it for almost 6 hours today and never had one leak. Thanks again

Thanks, I finally got it off with out any heat but it was a pain in the a$$ and the threads are not in the best of shape but I think I can get it back on but I think I am going to put a little never seize on it. I just put the seal kit on it but I have a little small o ring that I have no idea...

I was hoping to be able to get this off without messing it up because i have got to be able to put it back together this morning because i have to use it this morning and there is not a dealer close to me to be able to go get another one

I know this has probably been discussed 1000 times but i am in despirate help now. I have an 1998 751 and i have got to get the seals changed on this cylinder as fast as i can. i have the seal kit and i cannot get the aluminum nut off. I started on it last night and had no success. The holes...

Can somebody tell me if i can use a automotive temp. gauge on a 98 751 with a kubota engine. mine is not working and i would like to take the bobcat gauge out and put in a aftermarket one. thanks for the info

I have a 98 751 and i just asked this question to a power and hydraulic store where i live. They said that the aw 46 is a thinner oil than a 68. You dont really need to run anything thinner than a 68. I had put aw 46 in mine and i just replaced the seals in my hyd. control valve. I dont know if...

Thanks for the help. It was the spool seals. That was an easy fix. All i did was take the two bolts out of each one of the spools and disconnect the other end where it connects to the pedals and pushed the spools right out the other side. I did have to take the fuel filler hose off and loosen a...