Recent content by mtnxtreme

JCB and Volvo same machine, purchased partially unassembled we replaced motor and found a 10gauge red wire not hooked to anything, looks like it’s feed the Grid Heater Relay but can figure out where it should be hooked up to. Can anyone help here’s a few pics.

Has anyone had experience running a low flow brush mower on a TL8 ? There’s so many options I don’t know what settings to use. One way flow, two way flow, and 4 different auxiliary hook ups ? Thanh’s in advance if anyone can help !

Since there is no JCB or Volvo section thought I’d post here. Does anyone know where to buy the little rubber covers on joystick controls. I have just the little white plastic stem sticking up the rubber covers are gone and mfg. wants $2500 for a whole joystick. Also does anyone know where...

Thank You !

TriHonu this is probably a stupid question but I looked up these 6731119 - PIVOT, WEDGE, 50 mm (1.95") long pin. and for the life of me can't figure out where they go and why they need them. Also do you have to set it up so the actuator piston fully closes when in that position or will it just...

Pretty good idea are you putting a fan ?

Has anyone installed an aftermarket heater / AC kit in a skid steer that didn't have a factory unit ? If so, what did you use ?

I tried to fix it but cant figure out how to edit. Damn phone must have done that. Yes JCB, and any ideas ?

Just what I was looking for thanks !

2013 Volvo MCT135C has low compression in one cylinder. Only 1200 hours. Are these known for bay early issues with the motors ? And I know JVC made this machine for Volvo, why’s is the identical JVC model and is it cheaper to buy parts from Volvo or JVC ?

Does anyone make a manual to power Bobtach kit, and Lo Flow to Hi Flow kit for a Toolcat ?