Recent content by Ironmule

I haven't been able to take it in yet. I will be sure to post when I eventually get it to the dealer.

Thanks, I guess the trip to the dealer is in my near future..

Ok thanks for your input. The Hydraulics are strong on the aux circuit but it seems to lug the motor more than it should compared to other machines I have operated, as I have operated several different T250s and T300s. The lift and tilt dont seem to lug the motor at all but the aux hydraulics...

No shavings at all, it was clean.

Yes, I found and replaced one but I can't locate the second one that should be behind the left lift cylinder somewhere, I have removed the access panel and searched the world over with no luck.

One case drain is brand new, I cant find the other which was supposed to be on the left side of the machine, not sure which filter I have yet but will know this weekend as I am out of town. There was no change in performance when I changed the filters about 250 hrs ago. I am going to change them...

It does bog the motor pretty hard, I have always had to back off on the travel to let the motor catch up while pushing dirt or traveling up a slight incline, I was just doing some research and found that overall performance is poor with a low charge pressure, The rest of the hydraulics are...

My 2005 T250 has approximately 3400 hours on it. I purchased the machine with 2900 hrs on it. The machine sets the low charge pressure after idling for a few minutes after working the machine with everything hot. The hydraulics seem to bog the machine when doing multiple tasks, traveling and...

Not sure of the model but a T250 and 300 use a grease gun to tighten the tracks.

Thanks for the input guys. I was also looking at the Prowler EXT tracks (tractor like tread). Any thoughts?

I have been shopping for new tracks for my T250. I am looking at a set from summittracks.com. Has anyone had good or bad luck with these? I use my machine about 100 hours a year on dirt, sand and mud. I am looking at the straight bar design. I have looked at McLaren but they seem to be more...

Thanks TriHonu. Very helpful information. I will be calling them soon.

I have a bobcat T250 and some tractor implements I am going to remove the 3 point hitch and replace with attachment plates to fit my machine. What hydraulic motor do I need to achieve the 540 Rpm with a standard flow hyd. system on my machine. I'm needing the part # and brand for this so that...

I am interested in the attachment as I have access to several PTO driven accessories. Give me more info please.

It does have a turbo but im not sure how to check it for proper operation. When starting it, it usually fires up better hot. I am going to check the glow plugs, it doesnt sputter when trying to start, it just winds over longer than any other machine I have operated. I will pull the injectors and...