Recent content by Homer Allman

As the title says I have no tilt or lift on my Bobcat T 250 525611600 ACS. My sticks and locked side to side, but the tracks still work. Here's where it started and here's where I am at, now. I had a lift actuator code, so I replaced the lift actuator. The code went away, I did a manual...

thanks for the tips. I will put them to good use today. I appreciate you taking the time to answer.

I need to take the control valve out of my t 250. The metal tubing is the first thing that needs to be removed but they are so tight I'm afraid if I do any drastic I will break the valve body. Can I heat those lines and have a better chance of getting them loose? What other tips do you have for...

I get the 32-66 error code on my bobcat T 250 which indicates the battery voltage is out of range. I changed out the alternator and got the voltage back in line but I still get this error code. Anyone have any suggestions? Like where do I begin the figure this out? Thanks

thank you for the reply. I went ahead and purchased a new aftermarket alternator. It was almost as cheap as the parts to repair the old one. It should be here today.

I get the 32-66 error code on my bobcat which indicates the battery voltage is out of range. I looked in the service manual and saw how to test the alternator for high and low voltage. My test showed my battery voltage was high. it was in the 15.7 volt range. This means the alternator is...

I got it working. thanks for looking.

I got the 32-39 error code on my T 250. That code points to a bad lift actuator. I did the plug swap and get the 32-34 error code that says the tilt actuator is bad. So this should confirm that the lift actuator has some issues. I start working on the machine to replace the bad actuator. I find...

Thank you so much for your reply. I removed both actuators and found the bottom one the lift was bound up. I put a replacement motor of it and it seems to work fine now compared to how it was working. The actuator now moves in and out freely. I did put them back on and I still have the same...

I just did this on my lift actuator. My actuator had a 455a609 motor on it. It was obviously bad when I took it apart. I found the following motor on eBay below. I purchased it for less than 20 shipped. When I got it the gearbox was different but I was able to put my 609 gears in it and it fit...

I have the dreaded 32-39 code on my t 250. Here are my questions. Does the t 250 have two actuators or one for the lift and tilt. I have the service manual and it looks like two. I just want to confirm. My tilt and lift levers are both locked. If one of the actuators is bad why are both sticks...