Recent content by george.schneider@otgbrew.

Neutral adjustment was successful. Thumbs up.

Solved. Auxiliary spool spring thrust plates upside down.

Bobcat 763 - working one problem at a time here, it's been a journey. Sitting still I can operate tilt and lift great. When I drive, after a couple seconds. I hear some relief start to hiss. And the tilt and lift get slow to retract. I can't get this hiss to stop until I pop the manual lift...

Neutral adjustment was a success. Rotated cams and flipped centering blocks as well. There wasn't much error for the tires to stop spinning, I'm glad I lifted the entire machine, because that could have taken a long time.

"aux hydraulics have stuck themselves on" - think that was the problem. "As for the creeping, that is just a neutral adjustment of the plate that sits on top of the drive pumps." - havent adjusted yet

Hey, sorry, I thought my post got deleted. Since, I have replaced the coil and stem. But it was not the issue. It appears that the auxiliary spool was getting stuck causing some hydro-lock, I think I might have put the spring plate in upside down :[ hard to admit. But I also swapped the...

763 Bobcat Hello, I'm trying to trace down an issue with my tilt and lift not relieving pressure on the cylinders. I was wondering does anyone know a good resistance to the solenoid coil on the BICS directional control valve? I'm getting 10 ohms which seems low to my knowledge? I bench tested...

Bobcat 763 Hello, Recently acquired a bobcat from my father in law. He said it leaks hydraulic oil. I fixed the leak by changing all seals with Bobcat OEM parts on the BICS and Hydraulic Control Valve (leak was coming out of one of the spool piece end) Unit ran great for about an hour of...

1mm x 7.5mm x 9.5mm 1mm x 14mm x 16mm 1mm x 11mm x 13mm 1.5mm x 17mm x 20mm McMaster Carr