alchemysa, that is exactly what happened. Also, I'm assuming the brass gland (#6) is supposed to slide into the sheave freely. Mine does not want to go in further than the o-ring when pressing by hand. Does it usually require some persuasion?
The new seals just came in so I finally got to pulling the roto out. It looks like when I greased the roto zerk it pushed the roto out causing the leak.
I am a little confused about where this large snap ring came from / gets installed. Can anyone lend some advice?
Also, does anyone know the...
Has anyone had luck with an after market alternator? All the ones on eBay have fan blades (unlike the OEM one) but I ordered one anyway and it didn't fit. The pulley location was wrong and the fan blades interfere with the bracket arm. I may swing it by a local alternator repair shop to see if...
After my machine has been on stands for the past few months having the axle seals replaced I developed a new issue.
The driven sheeve has collapsed/closed pushing the belt to sit on top of the pulleys. Subsequently, when I started the machine the driven sheeve did not spin and withing 20-30...
I’m asking about the castle nut on the inside end of the axle. I am concerned about putting to much load on the bearings. I think I am good on the big nut since that bottoms out on the axle.
Great info, thanks. I was actually able to find a kit in stock at Loader Parts Source that I ordered. I will assemble the hubs on the bench, that is a great call out I would have done them in the machine. I have the hub gaskets so all set there. I can't remember which way they are on to be...