Recent content by desross

Hi folks i want to set up a third return ( pressure relief line on the front of the bobcat 753c ) so i can run a hydraulic motor at the front. at the moment i only have the 2 flat face couplings. MY question is where do i plum this third coupler line back too. ( Is there a port on valve bank )...

i am looking at making a fork lift mast on a axle, and then using a quick hitch on the back of the mast so when i pick up loads the weight goes on the mast wheels and doesn't lift the rear of bobcat up. my question is that i am only using one hydraulic hose as the ram on the mast is only single...

hi there thanks guys i got into mind today, hose/steel pipe joiners are behind the hinge of door.this is what i did remove hoses from where they hit steel pipes on arm, mark with pen which is which, tie string on so you can use string as draw wire to put new ones back on. 1.. take off metal...

hydro oil started coming at the back right, I traced the problem to a connection between a hose and a steel pipe. Which is in fact the bucket crown action hoses, from where it leaves the arm into the rear frame it appears to go into a short hose running down into a steel pipe, both of which cant...

Thanks for that , where might the hydrostatic pressure sensor be postioned, and what does it look like thanks

thanks for that :gave unit a clean and now i can read it, Get code hp-3 , Any thoughts on that.

I have just brought a 753 c-series and i have 5 questions if someone can help please 1.. after start up about 5 seconds later there is 3 beeps ( does this mean something ) 2.. my LED display top right hand side is very faint and i can't see anything, what can i do to fix this. 3..there is a...