Recent content by daddygoose

I was having issues with the fuel transfer pump keeping the fuel/water separator full when I started the machine so I installed a brand new one yesterday. After the machine has been running for several hours with the mulcher at WOT I start to loose power when I'm turning or cutting into thick...

I have an 05 cat 257b skid steer with brand new perkins engine , resealed all 4 cylinders and no leaks. So far I've replaced the bypass valve in the back that releases pressure to lower the boom. I've replaced the main PRD on the valve assembly part # 456-1787. After the machine has been...

Havent tried that yet, but looking at all my options. Ive just about got this thing where i want it. I built a forestry mower for it and wanting to help the water tempature as much as i can. the stock radiator is a two core . im looking at maybe putting a 4 core if i can find one.

Im looking for suggestiong on where to find a replacement radiator for my 86 Scat Trak 1050. its seen its better days so its time to move on. Anybody have any suggestions on where to find one.

IN the past forums i had asked about using 10w30 motor oil for the Hydrolics. found out this is ok. My question now, the Kubota 4 cylinder diesal engine uses the same weight oil 10w30 . is there a difference in using regular motor oil or does it need to be a diesal motor oil like rotella or...

i found a PTO drive motor on Surplus Center with the spline drive i need. but my question is the flow rate is 17.1 GPM cont and 21.0 int. Pressure 2576 PSI cont and 3091 int. turning 800 to 990 RPM,s with a torque of 1682 in-lbs.cont. my machine only puts out 9 GPM with 2150 PSI. i dont want...

what would be the required rpm and torque for a hydraulic motor run by a 9 GPM 2100 psi system. it has a 12 inch bit on it. im figuring the torque is more important than speed on this piece of equipment.

what size is your Skat trak i have the manual for the 1050 and the 1350 I can email it too you if you need it.

Mick did you ever get the manual i sent you.

send me your email and ill send you the manual I have the the same machine i bought it about a year ago. been working fine untill about a week ago. the drive motor on the left side quit working. so im in the process of trouble shooting that . but its a good little machine .

i have a manual electronically for the 1050 and 1350 . just send me your email address and ill send you a copy. the 1350 has the V1902B which is a 40 HP. the 1050 has the D1402B which has 32 HP.

i used a 1 3/4 socket on a breaker bar to turn the center shaft. im gong to have two hoses built so i can actually just take the good side of the hydrostatic pump and put over to the motor in question and do the same with the good motor. that way i can test both the motor and pump. i do know the...

that would prove the pump is working. and wouldnt require the gage. thats a good thing about these forums. always another ideal out there. Thanks.

I have a 86 1050 skat trak that has lost all power on the left set of tires, everythinge else on the machine works fine. Ive pulled off the inspection plate and the chains and sprokets all look good. i can put a socket on the center pulley and it turns both wheels, so i know nothing is stripped...

has anyone pulled the wheels off to repair a seal on he drive motor. My motor is leaking hydraulic fluid and i need to have an idea on what to expect before i tear in to it.