Recent content by cdmccul

Help Support SkidSteer Forum:

  1. cdmccul

    Damaged lift cylinder head - repair or replace?

    Looks good! With perspective and reflections, hard to see exactly... Going to have to massage it a little bit and clean it up with a file?
  2. cdmccul

    Mustang 2044 Hydraulic Problem

    Quando omni flunkus moritoti! I'm well versed in Red Green! I'm just confused on the relevance... I didn't see the connection, unless the comment was "no, I want the real thing, not a red-neck solution." Thankfully, my wife finds me both handy, AND handsome! ("Welcome to Harold's Handy...
  3. cdmccul

    Mustang 2044 Hydraulic Problem

    O.o huh?
  4. cdmccul

    New member intro

    Welcome aboard!
  5. cdmccul

    Bobcat 773 leaking oil around axles

    What did you put in the chain case for oil?
  6. cdmccul

    10W30 with HTO or Hydraulic oil?

    I think there's is also a level of confusion based on how old the machines are... A machine made in 1999, will have a call for oil of that era... And then my machine from 1979, for the same thing called "oil" will be a different spec. Like it was said, do your own research based on what was...
  7. cdmccul

    10W30 with HTO or Hydraulic oil?

    I know it's a dead horse... But your post above contradicts itself. And the dealer was of no help. "Yes, we see it is to use 'this' and 'this'." "Ok, I'll take both." "I'm sorry, that isn't available any more." "Ok, then what do I need???" Your own post also says "designed for something that...
  8. cdmccul

    Where did my post go?

    I had this issue too. I was waiting for the post to get approved. Now that I've been approved, I don't seem to have trouble getting approved now. I believe I sent a question to the admin... I'll have to go looking for what I did!
  9. cdmccul

    how do I delete a post made in the wrong place?

    Depends. If you set it in concrete, best practice may be to use the skid steer. If it is a steel post, you might wrap a chain around it and then leverage it out using the tilt function. If hollow pipe, and you don't want to keep it, possibly cut a "birds mouth" in the bottom of the pipe and...
  10. cdmccul

    Mustang will not start.

    If it doesn't start, that doesn't rule out that it isn't a bad solenoid. And you would have 0 across those two points.
  11. cdmccul

    Mustang will not start.

    Where are you checking that you get "0.00"? There are different circuits to a relay or solenoid, and each one has differing test results.
  12. cdmccul

    Bobcat s300 No start

    Starter solenoid likely had burned contacts. You may be able to disassemble and coral them for a temporary fix
  13. cdmccul

    Mustang will not start.

    Sound like a good chance, yes. At the signal line to the starter relay you say you have zero volts, or you have zero at the incoming high current supply?
Top