I checked variable flow with my 4-1 bucket and it worked. So it must be something with the pedals.
I put a multimeter on the foot sensors. I am getting just under 5v on the left and right side. Is that what it's suppose to be?
I have .6 ohlms on both sides also. What should it be for this...
There is this post: https://www.heavyequipmentforums.com/threads/bobcat-s220-tilt-and-lift-problems.29605/
I wonder if that is the issue?
There is a left and right foot sensor. It would seem odd if both are bad? Would one going bad really affect both pedals?
There is a solenoid for reach...
I have a Bobcat S220. Both pedals seemed locked and provide no response. I checked for error codes and there was none. I also checked the pins for the pedals and they were attached. Any ideas? Could it still be the solenoid, or something mechanical?
I have a Bobcat S220 with a 4-1 bucket. It almost always operates correctly. One in a while the bucket will start opening and closing without any input. I can only stop it by turning off the machine. When I restart it, the bucket operates correctly. Could this be an electrical issue with the...
I am new Bobcat owner. I keep it outside and have noticed water collecting on the skid plate. I have tried to drain it by lifting the front with the bucket, but I am not able to get all the water out. I am also thinking about cleaning it with a pressure washer so I would like find out an easy...
I am using a Bobcat for some work on my lot. It doesn't always happen. Usually turning it off or raising and lowering the armrest works. But there was an incident today when I had to go through several cycles of turning it off and on and raising and lowering the armrest. I didn't have a load in...
I am looking to buy an S220 for person use to clear gravel from property I just purchased. I found one for sale with 1,600 hours on it for around $16,000. Tires are worn. The engine was rebuilt recently. This is my first time purchasing heavy equipment. Is that a good value? Thanks!