Yet another Canadian

[spitzair]

Hello Folks, I'm new here, I have been hanging around www.heavyequipmentforums.com quite a bit and somebody posted the link to this site so here I am! I work out of Okotoks, AB and home is Squamish, BC. I've recently bought an M444 Bobcat and there's a 1981 Bobcat 732 and a '98 873 C series in the family. I probably won't be of much help to anybody here but I'll do my best to help out where I can. Toby

 

[glenbell]

Welcome from Cranbrook BC.....

 

[coreya3212]

Welcome from Cranbrook BC.....

Welcome Spitz, we are practically neighbours. DeWinton here.

 

[Heater77]

Welcome Spitz, we are practically neighbours. DeWinton here.

Calgary here. I work for Conterra Attachments, we build skid steer attachments near Strathmore, AB. Thomas

 

[skidsteer.ca]

Calgary here. I work for Conterra Attachments, we build skid steer attachments near Strathmore, AB. Thomas

Welcome, from Emo Ontario.
There is a few of us around.
Ken

 

[sd463]

Welcome, from Emo Ontario.
There is a few of us around.
Ken

hello and welcome i live in laclabiche alberta and own a oil field construction comapany up here. Steve

 

[skidsteer.ca]

hello and welcome i live in laclabiche alberta and own a oil field construction comapany up here. Steve

Welcome Steve
Ken

 

[gatechalky]

I just purchased a very used Bobcat that I don't know the exact model but I believe it may be an M444. It has a two cylinder motor. It has 4 (7 X 15) and is two wheel drive. It has a gasoline engine with two tanks. It does not have a key start (has a switch for turning fuel pump on and off and push button starter). There are two gauges on the panel by the switch and starter (pressure and ammeter) It has the Bobcat name and emblem on the arm. There are two floor controls with a separate control for unknown on the left side wall behind the left pedal. It has a roll cage that appears to have been added by a previous owner. It is air cooled and has a large hole on either side behind the rear tire. Does this appear to be an M444. I bought the service manual for the M444, M500 etc but it does not show any pictures of the different models. Thanks for any help you may provide. Alan Bundy