Hi All
’m revamping my old bobcat and at times I think I know just enough to be dangerous.
My Hydraulics at the moment only work when I push the traction unlock button then use the attachment switch on right lever.
I went to control valves and swapped leads on solenoids to see if that was the issue. No it performs the same.
When I just push traction release I’m getting up on arms and tilt. It sounds like my fast flow is not switching on either. When I use the auxiliary switch on right lever the revs noticeably “free up”
I have a full manual, I’m currently thinking it’s not the control valve as I swapped the leads to rule that out. On the electrical drawings with my magnifying glass I’m getting a bit lost.
Any thoughts ?
’m revamping my old bobcat and at times I think I know just enough to be dangerous.
My Hydraulics at the moment only work when I push the traction unlock button then use the attachment switch on right lever.
I went to control valves and swapped leads on solenoids to see if that was the issue. No it performs the same.
When I just push traction release I’m getting up on arms and tilt. It sounds like my fast flow is not switching on either. When I use the auxiliary switch on right lever the revs noticeably “free up”
I have a full manual, I’m currently thinking it’s not the control valve as I swapped the leads to rule that out. On the electrical drawings with my magnifying glass I’m getting a bit lost.
Any thoughts ?
