M600P - Petter Diesel Governor / Rev control linkage

[M600-Des]

Hi All, My 1st visit here so if this is in the wrong section I'm sorry. My Bobcat is an M600P. I'm not really sure of the manufacture date but it's OLD! I am in the final stages of rebuilding my Petter twin diesel and am struggling to workout how the rev control linkage should connect to the governor arm(s) on the front of the engine block. Does anyone have any photos? I would post some photos myself but can't see how to do that just yet ;-) The Bobcat serial number is: 4952A1125GEM All help gratefully received! Des

 

[mahans7]

Hey M600P, I can't help you with the linkage but I can try my diminishing picture posting skills if you'll email me the pictures. Just look up my profile and I;ll get them up.

 

[jerry]

Hey M600P, I can't help you with the linkage but I can try my diminishing picture posting skills if you'll email me the pictures. Just look up my profile and I;ll get them up.

Do you have the service manual, pretty sure the 600/610 manual covered the petter diesel good. If you dont have it contact old machinist , he may have a link to pfd file.

 

[M600-Des]

Do you have the service manual, pretty sure the 600/610 manual covered the petter diesel good. If you dont have it contact old machinist , he may have a link to pfd file.

Hi Both, Sorry for the slow reply. I got this figured out in the end and then forgot to take any pics so that others could learn - Really sorry. If I ever need to take the engine out again I'll get photos. Thanks again, Des