Hydrostatic pressure problem

[fixingthefarm]

Hello to all, new to the site as of this post. Thank-you for looking at my post!!! I have a set of Easton pumps that i removed to put seals in the rears. I also addressed a servo problem. My issue is, after reinstaling the pumps I have no Hydrostatic pressure???? The hydrodrulic pump is working properly, but I have no pressure on the high side. The pumps were not disassembled prior to instalation. Just seasls and a adjustment to a servo. I disasembled the charge pump thinking the key must have sheared off, but no, it did NOT. So, can anyone help with a bench test on the charge pump, and perhaps some info on routing to see if the motor after the pump is recieving pressure, and so forth down the line...... THANK YOU SO MUCH

 

[Mike10]

Did you install a gauge in the charge pressure circuit to see if there was charge pressure? Not sure what model you are working on but if you had the servo controllers off you may have installed the gaskets backwards and blocking one of the small holes or you did not get the lever on the control in the right place when you installed the control back on the pump.

 

[fixingthefarm]

Did you install a gauge in the charge pressure circuit to see if there was charge pressure? Not sure what model you are working on but if you had the servo controllers off you may have installed the gaskets backwards and blocking one of the small holes or you did not get the lever on the control in the right place when you installed the control back on the pump.

Thank-you for the responce Mike10. I did install a pressure gauge in line, as per the location of the T for the pressure sensor. Only 1 servo control was removed, and it was the opposite pump. And yes it was reassembled correctly. Thanks