how to wiring a turbo saw wiring harness to a J.D. 260 skidsteer.

[kauz]

need advice on what is the best way to run the wires in side the cab of the skidsteer so that i can raise the cab up without disconnecting the wiring harness, and also where is the best place to connect the power wire so it only has power when the key is in the on position? any advice would be greatly appreciated.. kauz

 

[Tazza]

Not sure where to find switched power, but for the routing into the cab, this should be pretty simple. Find where the cab tips, run the cable in from here, the wires will only flex, they will not need to get disconnected, this is how Bobcat machines are routed, i assume yours should be equally simple.