Hi all, Not much of a grease monkey but trying my best. We have an old 763 Bobcat. She was working fine about 2 weeks ago, but today when I go to use my Titan planetary auger I find it will only run in reverse - left toggle on the right joystick. Trigger and right toggle don't seem to do anything. I went and put on my Titan flail mower that has been under a lot of use recently and it again only runs in the one direction - its forward is the left toggle. It was going in its reverse (right toggle) just fine a week ago but I don't think I've had cause to go in reverse last few times out so not sure when it stopped working. Lift/tilt of the arms seem fine, as is steering and movement. Just the right toggle and trigger on the right joystick aren't responding. Anyway, question I'm hoping for some help with is where is the most likely place I should be starting to investigate? I don't know if it is the electronics in the joystick, some sort of valve in the hydraulics, some control input somewhere? Based on the symptoms described is there a good place to start looking? Thanks in advance -o