Serialgriller
New member
- Joined
- Aug 6, 2019
- Messages
- 2
I have an ep3 code showing up when I start the bobcat. I had lots of codes yesterday but after tracing wires for 3 hours all of them are off except ep3. I tried tracing the wire from the oil pressure gauge and I was able to track it to the harness/black box under the cab. However the black wire I was having trouble tracing or get the cable tracker to have a loud tone when hooked to the black wire. I'm not sure what causes that. I'm thinking it is the black wire broke, bad fuel pressure sensor or burnt fuse. I can't find the fuse box location even after tracing wires for hours. I tried googling it and I don't see them on the bottom right in the engine compartment. I think that was done with the 753f. Anyone have and recommendations on what is setting the code or also where the fuse box is located?