873 LIFT ARM

[The Extractor]

Hi , I need a used a 873 lift arm. Sources ? Thanks - A

 

[antfarmer2]

Where are you?

 

[The Extractor]

Where are you?

Western CO

 

[antfarmer2]

Western CO

Call 877-530-5010 this is a big tractor scrap yard up there might be some info sorry best I could find

 

[The Extractor]

Call 877-530-5010 this is a big tractor scrap yard up there might be some info sorry best I could find

Didnt find one yet but thanks for the help.

 

[antfarmer2]

Didnt find one yet but thanks for the help.

Found some in Mich and Indy I think but a bit far for the post man

 

[The Extractor]

Found some in Mich and Indy I think but a bit far for the post man

Its for a customer it would be ok to ship it probably.

 

[antfarmer2]

Its for a customer it would be ok to ship it probably.

Ok found a place in Illinois looks like they have four of them scraping out 618-833-5498

 

[The Extractor]

Ok found a place in Illinois looks like they have four of them scraping out 618-833-5498

Still need one fellas. Thanks !

 

[Mikefromcny]

Still need one fellas. Thanks !

Have you tried wengers of myerstown, pa? What series is your machine, c, f, or g? betting its not a g.

 

[[email protected]]

Have you tried wengers of myerstown, pa? What series is your machine, c, f, or g? betting its not a g.

bobcat of NH has one http://www.bobcatnh.com/pre_owned_detail.asp?sid=4618472E-02X2K4K2014J8I43I01JPMQ4501R0&veh=1710666

 

[The Extractor]

bobcat of NH has one http://www.bobcatnh.com/pre_owned_detail.asp?sid=4618472E-02X2K4K2014J8I43I01JPMQ4501R0&veh=1710666

Thanks guys I will check those out. I need a G series arm.

 

[The Extractor]

Thanks guys I will check those out. I need a G series arm.

Bump I still need one guys! Thanks !

 

[Bobcatdan]

Bump I still need one guys! Thanks !

If they are cracked like they always are, have a weld shop fix them.

 

[The Extractor]

If they are cracked like they always are, have a weld shop fix them.

I am the weld shop. These are junk multiple repairs and they are bent and the rear pin holes are ripped off.

 

[Tazza]

I am the weld shop. These are junk multiple repairs and they are bent and the rear pin holes are ripped off.

The rear pivot points can be replaced, the bends can be fixed, but will not be easy.
Have you thought about a lisitng on craigs list? see if anyone has leads