773 BICS problem

Help Support SkidSteer Forum:

rgk

Member
Joined
Jul 20, 2022
Messages
5
Working on a 1995 773c that I recently purchased. Machine was very dirty from use at a grain elevator. Had the loader raised in the locked position the past couple weeks cleaning (sprayed water) out belly that was full of junk and drain holes plugged. I started machine today and can not get the boom or bucket tilt to move. I assume a problem with the BICS. Where do I start with trouble shooting? Also have an accessories fuse that was blown, replaced and has blown again. Maybe got some water in areas I shouldn't have? It has been over 2 weeks since and water was used to clean, thinking everything would be dried out by now.
 
OP
OP
R

rgk

Member
Joined
Jul 20, 2022
Messages
5
I just went out and started machine and noticed the seat light was not on the BICS panel. I did remove the set for cleaning and must have disrupted the seat safety switch.
 
Top