The first motor rebuild went fine. While I was doing the geroler section of the second motor four of the rollers fell out when i turned it over to replace the o ring.I know there is no way I was able to put them back in the same place they fell out of, from what I now understand everything must go back the same way they were. Two of them went in fairly easily but the other two were extremely hard to get in.I have tried to turn the shaft but it feels extremely tight.I"m reluctant to put the motor back in the machine as I don't want to cause any damage to the machine. Is there any way to break it back down and figure out the correct way to get it back together the way it should be? Thank you for any suggestions!
