443life
Member
- Joined
- Feb 22, 2015
- Messages
- 23
here i am again... lol after fixing all the hydraulics everything was going smoothly until i broke a pin off my harness that goes from rops to engine. i re-wired everything to a generic harness and im 100% sure its all been wired up right however i cant seem to get it to continuously crank over. i originally shut off the fuel switch to change the filter and ran the bobcat out of fuel. while doing so i changed the glow plugs as maintenance, after everything was replaced i tried to turn it over and some times itll crank but mostly it doesnt. can any one shed some light on what this could possibly be or have had any similar problems? maybe a bad solenoid or relay? any help would be appreciated thanks !