While I was moving snow the skid started intermittently running at low RPMs. Now it will start and sputter around 100 to 400 RPM for a few seconds and quit. The 3029 code says the oil pressure sensor is shorted and I replaced it. The 1203 code is for RPM sensor.
I heated everything up and same issue. If I let it set for a while, it will run a few more seconds than if I start it back to back.
I don't know if the errors are causing the problem or if they are a result of it not getting to the operating RPM it is expecting.
I will replace the 3rd filter, by the engine. I am looking for any info on these errors. The service manual is pretty vague. If someone has the wiring diagram and location of the RPM sensor it would be much appreciated.
I will call the dealer to see what they say, Monday.
Replaced oil filter, 2 of the 3 fuel filters, oil pressure sensor.
I heated everything up and same issue. If I let it set for a while, it will run a few more seconds than if I start it back to back.
I don't know if the errors are causing the problem or if they are a result of it not getting to the operating RPM it is expecting.
I will replace the 3rd filter, by the engine. I am looking for any info on these errors. The service manual is pretty vague. If someone has the wiring diagram and location of the RPM sensor it would be much appreciated.
I will call the dealer to see what they say, Monday.
Replaced oil filter, 2 of the 3 fuel filters, oil pressure sensor.
Last edited:
