2008. Case 430 skid steer, lift arms and bucket do not move

[rzylonely]

Hello I have a 2008 430 case skidsteer. Lift arms and bucket not working. I pulled all fuses they seem fine. I can move forward/backwards side to side. So driving is fine.. no bucket controls/ HELP

 

[flyerdan]

Moved to the Case forum where hopefully someone knowledgeable will see it.

 

[rzylonely]

Moved to the Case forum where hopefully someone knowledgeable will see it.

I have now pulled all relays and cleaned connects

 

[Gearclash]

I have now pulled all relays and cleaned connects

Is this a Series 3 or a plain (older) 430?

 

[rzylonely]

Is this a Series 3 or a plain (older) 430?

it is a series 3. I need to figure out how to lift the arms/bucket to tilt the cab also?

 

[Gearclash]

it is a series 3. I need to figure out how to lift the arms/bucket to tilt the cab also?

Since it is a Series 3 I can't offer any help. My experience is with the previous series.

 

[rzylonely]

Good day Thanks for any help anyone has or can help me with. I have the arms/bucket raised and supported on the factory Case safety supports. Cab is tilted forward. What I have tried so far. Checked fuses/relays. All seem fine. The skid steer will move around no issues with the ISO part of the steering. The lever for the bucket/arm controls is DEAD. I have have a service/repair manual now. I need ideas of what could be the problem? I am flying blind HELP. 2008 Case 430 series 3 model. Thanks Barry

 

[farmkev]

Hey Barry, I am experiencing the same issue, were you able to get yours resolved?

 

[rzylonely]

my issue was the cab door safety switch... located a break in the wiring.. all is fine now